The annual holiday tradition of carving pumpkins to make jack-o-lanterns running the gamut from sweet to ghoulish is one that is filled with picture-taking opportunities. Get up above the action to capture all of the fun, and zoom in close to get great detail shots of the tools and mess involved in pumpkin-carving. See the shots below for examples. But after the mess is all cleaned up and the sun has gone down, set out your pumpkins and light them up for a great shot. Make sure your camera is stable. Using a tripod is highly recommended. Next, turn your ISO down low to 100 or 200. Your exposure will be long and you do not want to create unnecessary noise in your shot. Set you camera to manual exposure and open the aperture to about F/4. Fill your frame as desired and shoot, using a cable release or remote control to avoid any camera shake when you trip the shutter. If you do not have a release, you could set the camera to self-timer. Adjust your shutter speed to 30 seconds and take a shot. The photo will be either too light or too dark. Adjust the shutter speed to faster, like I did here to 15 seconds, if the photo was too bright. If it was too dark, add more time to the exposure. I had two other pumpkins on either side of this one, so the ambient candle light was picked up during the long exposure to make a nice fun jack-o-either portrait.
Tonight is the perfect night to light up your carved pumpkin and snap a few spooky shots. I found that taking a shot a little bit after the sun sets, while there is still some light left in the sky, can make your pumpkin look more scary. The tree branches will be back-lit, which adds to the mood of the shot. Start by setting your camera to aperture priority and selecting the widest aperture your lens allows (F/2.3, F/3.5) and a low ISO (200 or 100). Next, put your camera on a tripod or other stable surface. Using a cable release or electronic remote control like I did will ensure that you do not get an blur when you press the shutter release button during your long exposure. If you have a lens with an anti-shake mechanism (like Tamron’s VC, Nikon’s VR or Canon’s IS systems), be sure to turn it off when using a tripod as it is counter-productive to use the stabilizer system in that situation. Then, shoot your pumpkin at a lower angle using a wide angle setting on your lens to get some of the trees in the background. You can add extra exposure if your background is too dark by using the exposure compensation dial and going to the plus side. This slows down your shutter speed even more. Your exposure will be somewhere around 15 seconds to get the soft glow of the jack o’lantern and the bluish sky in the background.